![]() ![]() this will need to be high enough to avoid the pump pressure pumping water out of the riser. Install a tee and riser at the highest point of the pipe. You will lose a bit of water this way, but if it is above the tank, the water will drip back in (provided it doesn't spray too far.) You could even put it just under the tank lid. Make a pinhole in the highest point of the pipe. You want to let air into the pipe when you switch the pump off, without letting water out. Thank you everyone who took the effort to write an answer, and that too with detailed explanations. Will use it when I install such a system again where the tank is at a considerably higher place than the plants. I also like the option of using a solenoid-valve, but have not tried it yet. Completely loved it, more so, because it does not involve procuring new stuff. I tried the suggestion of "Making a pinhole in the highest point of the pipe." It worked like a charm and solved the issue I was facing. Please note that I plan to automate the switch-on/off of the pump using a timer so that it functions without requiring my physical presence. How can I stop this water flow without requiring any physical action? But even after that, the water keeps flowing through the system and stops only when I physically lift the pump out of water. ![]() I switch on a small pump to start the drip-irrigation system and then switch it off. Please have a look at the attached image. ![]() I have assembled a small DIY drip-irrigation system for my terrace garden. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |